Blacksmith's tip: there are a few ways should mark your steel once you are measuring for your cut. One solution is to lay your steel ruler on your face of your anvil aligned with the bed edge and measure out of desired length of the steel. Then, using the sharp fringe of the back of your anvil, down the road . lightly mark your desired measurement by striking the steel against that edge with a hammer. Compensated with an increased a visible dent that you should be able to get easily despite heating for orange environment. Another method for marking is using something called "Soap Stone veneer for bathroom walls". It can be a stone with regard to naturally soft, leaves a clearly visible white mark (almost like chalk) against a steel surface, and is very in opposition to heat. This mark will remain quite visible even after enduring high temperatures the actual forge fire flames.
Brick masonry is also commonly put to use. In fact it is one of the poplar regarding stone masonry used currently.
